What-If Scenarios
Ask the assistant what happens if a risk is halved, an activity is shortened or a cost changes, and see the scenario’s P80 next to the base run.
How It Works
Describe the Change
Tell the assistant what to change: risk probability or impact, activity durations, the spread of duration uncertainty, or cost elements.
Run It
The scenario runs on a copy of the model. The saved model does not change.
Compare
A card shows the scenario’s results beside the base run, with the exact changes listed.
Details
What You Get
- Scenario analysis driven by the assistant.
- A scenario uses the last run’s iterations, up to 20,000.
- Cost changes are shown on the card next to schedule changes.
Limits and Conditions
- What-if runs from the assistant. There is no scenario panel on the page.
- Needs a run of the model in the session first, of up to 20,000 iterations.
- A scenario does not carry every setting of the base run, such as correlations and logic rules.
- Running a scenario needs an analyst seat, as any QRA run does.
Auto What-If
Ask the assistant for the levers that pull the P80 in most. It tries each lever in the same Monte Carlo engine and ranks them.
- Takes the activities with the highest schedule sensitivity and shortens each by 15%, and the risks with the largest schedule impact and halves each one’s probability. Four of each by default.
- Each lever runs through the same engine on a copy of the model, and the list is ranked by how far it pulls the P80 in.
- Uses the open run’s settings, and its seed when the run has one. Logic rules are not carried over.
Limits and Conditions
- Opens only from the assistant.
- Levers are suggestions. The model changes only when you change it.
- Needs an analyst seat, as any QRA run does.